We employ the following testing
procedure for ensuring effective quality in our product range:Pipes, Pipe Fittings, Flanges
Raw Material Testing
The raw materials, which are used to manufacture our range of
fittings and other allied products, are tested to ensure requisite
chemical and mechanical properties. For this, we use approved
measuring instruments.
Dimensional Inspection
Each flange and fitting is checked for dimensional accuracy using
calibrated measuring instruments offered by government approved
calibration agencies.
Hydro Test Up To 15000 PSI
Various types of fittings, flanges and valves are tested at a
proposed static pressure for a specified time period to ensure no
leakage.
Vibration Test
We facilitate vibration test for fittings and valves, in which these
products are tested for severe vibration under impulse pressure to
ensure no leakage.
TESTING
STANDARDS & PROCEDURES
We offer special tests desired by our clients. These entire tests
are certified by our quality control department. Some of these tests
for Pipes, Pipe Fittings and Flanges include:
Pneumatic Gas Test
The compressor & threaded fittings and valves are subjected to
pneumatic tests at 150 PSI air pressure and 2000 PSI nitrogen
pressure. This test is carried out after hydro testing.
Helium Gas Test (Hg-test)
We provide this test on special demand of our clients.
Pressure Cycle Test
Our range of fittings and valves is subjected to pressure cycle
test, which is carried out from 0 PSI to 5000 PSI. Using digital
counters, we conduct the test at the rate of 25 to 45 cycles per
minute.
Temperature Test
We provide temperature test for fittings and valves on special
request from clients. In this test the fitting & valves are heated
up to 350 °C for one complete cycle of 4 hours. |
